skip to content »

cloudcongress.ru

Updating firmware on cd burner

Any copy, reuse, or modification of the content should be sufficiently credited to CCM (ccm.net).

Needless to say you should bear in mind the following: During flashing of the updated firmware, the light on your burner should flash. Don't feel like getting a replacement chip if the power goes out in the middle of an upgrade!!! Had to post here tonite cause I upgraded my mother board bios and even tho I'm a cert, it makes me nervous when I have to do it.power it off, not just a reboot) and it should come good during the subsequent boot up.The tray should also retract by itself by you can manually retract it yourself at this point by pushing the button on the front of the drive.Don't feel like getting a replacement chip if the power goes out in the middle of an upgrade!!!

is there anything that can be done after updating the firmware????????

This text is odd as the two prior references to the Manufacturer ID of “CMCMAG” had Media Type IDs of “BAx” where x was a number.

Potentially, the “BB5” is a typo and was meant to be “BA5” so I am going to try changing it to “BA5” and save the firmware file under a new filename in the same folder like “main_firmware_new.bin”.

You may choose any one of the below - install updates immediately, click open and then run the program from the initial location, or save and download to your computer for installation later, and then click save to save it on the hard disk. Windows will usually install a default driver for them.

If your CD/DVD burning software does not recognize your drive, you should update the software.

LTD-165H: Not upgradable, mediatek chipset.i was able to get my HP 8100i 8/4/32x CDRW drive to 10x specs using a different firmware.